Arduino Code - Revision history

ThePlaz: fix led

2009-12-09T20:24:24Z

fix led

ThePlaz at 20:11, 9 December 2009

2009-12-09T20:11:39Z

ThePlaz: Created page with 'const int buttonPin = 2; //the button is on port 2 int buttonState=0; //if pressed int ledInPin = 1; //the led is on 1 void setup() { //turn on internl led pinMode(17, OUTP…'

2009-12-09T05:38:36Z

Created page with 'const int buttonPin = 2; //the button is on port 2 int buttonState=0; //if pressed int ledInPin = 1; //the led is on 1 void setup() { //turn on internl led pinMode(17, OUTP…'

New page

const int buttonPin = 2; //the button is on port 2
int buttonState=0; //if pressed
int ledInPin = 1; //the led is on 1

void setup() {
//turn on internl led
pinMode(17, OUTPUT);
digitalWrite(17, HIGH);

// initialize the button pin as a input:
pinMode(buttonPin, INPUT);
//initalize input monitor led
pinMode(ledInPin, OUTPUT);
digitalWrite(ledInPin, LOW); //set the LED to off
// initialize serial communication:
Serial.begin(9600);
}

void loop() {

buttonState = analogRead(buttonPin);
if(buttonState>850){
digitalWrite(ledInPin, HIGH);
}
else{
digitalWrite(ledInPin, LOW);
}
Serial.println(buttonState);

}

@@ Line 5: / Line 5: @@
 void setup() {
-   //turn on internl led
+   //turn on internal led
-   pinMode(17, OUTPUT);
+   pinMode(13, OUTPUT);
-   digitalWrite(17, HIGH);
+   digitalWrite(13, HIGH);
     // initialize the button pin as a input:

@@ Line 1: / Line 1: @@
 const int  buttonPin = 2; //the button is on port 2
 int buttonState=0; //if pressed
@@ Line 33: / Line 34: @@
+}